TOP3400B banner welding machine
Product parameters:
Power:3600W
Voltage:230VF
requency:50/60HZ
Welding thickness:0.2-3mm
Fan:DC Fan,stronger wind,more uniform air
Temperrature
ranger:0-700℃
Walk Speed:1-15m/min(20-25/min available)
Auto-dormancy
control:protect heating element,make machine lifetime longer
Laser:laser
positionning line,more accurate
Handrial:standing
to operate,move maching conveniently
Welding
width:2-4.5(wheel width 4.8th)
LED light:more
convenient work in night
Temperature
control:digital temperature control,digital dispaly,temperature float±1℃
Heating
element:Top 3400Bis Leister heat gun
Scope:banner,tent,waterptoof,tarpaulin
and so on.
Specification:
Model:TOP3400B
Size:63*48*39cm
Net weight:25KG
Gross weight:35KG
Operation:
1.Make the cloth for seaming flat and tight,. take joiner to accurate (about
2-4.5cm),Fix both ends by tape or glue on ground.
2.set the temperature and walking speed: Connect the power supply, set
the temperature and walking speed according to the thickness of the cloth.
Temperature and speed is adjustable. As shown:
3.
Turning the heating switch (yellow knob), the machine starts to heat up. Wait
for 2 minutes,when actual temperature (PV)approach desire temperature(SV),we
can start weld.
4.Welding positioning. Lap welding pressure(working wheels)- wheel edge must be
aligned with the upper edge of the banner, but also aligned with the guide
wheel on the side edge of the banner. As below:
5.Lifting the handle, making the working wheel on ground,as the show
6.start welding: pulling the heat gun to position handle and making the nozzle
close to ground then move the nozzle to left so that it can be place a right
position, at that time, the welding will work automatic.
7.During welding,let hot air nozzle between two overlap pieces. And be make
sure hot air nozzle and Rubber wheel walk in straight line.if not,please adjust
by handrail.check photo:
7.Turn off the switch: when finished,